Base plane. Base plate with U-shaped hole, 40 mm wide, with a 90 mm long indentation at the back. Cut-outs on the right and left for the two knob handles. The entire plate is bordered at a height of 6 mm. In front, above the U-hole, is a half-round 6 mm thick bridge with a cast cylinder Ø 10 mm inside for the chip breaker, with a small 5 mm screw and WITH WORTH 55° 32 G 5/32" thread. At the back in the middle is a 30 mm high cam 19x16 mm with right-angled cuts at the front and back at full height, serving as an iron stop. A threaded rod, 36 mm long, stands vertically in it for the thread WW 55° 24 G 3/16 7/32". On the right and left are threaded cams Ø 14 mm, 10 mm high, with a 3 mm high edge Ø 27 mm for the wooden handles, 6.3 cm high, Ø 21–41 mm. They are held by a threaded rod, 57 mm long, Ø 5 mm WW 55° 20 G ¼", and a 13 mm bronze nut Ø 11 mm. The iron holder is a solid 18 mm high oval ring, 46x31 mm, with a hole 10x17 mm and 32 mm long, 5 mm clamping screw WW 32 G 5/32". A nut Ø 18 mm with a 4 mm edge on top runs into the plane slot, on the 37 mm long threaded rod, and regulates the iron depth. The irons can be attached at the front and back in both slots. The chip breaker is a 3.5 mm plate, 15x38 mm, cast with a 12 mm high cylinder Ø 10/15 mm at the back. An 84 mm long Ø 10 mm rod, 6 mm at the top, runs into the bridge cylinder. The foot can be adjusted to about 40 mm under the sole. The side stop 43/38x42/38x10/7 mm (L.B.H.) with a 27x5 mm slot and two 40 mm long, 1 mm high, 2 mm wide raised guide strips can be attached on the left and right with two 21 mm spaced threads and a 44 mm long threaded rod in the two through slots in the sole. It can also be rotated and fixed. Comes in the original box with instructions.

1. Iron: 11 mm, pointed grind, bevel on top, angle 20°, shaft 10x10 mm with beveled edges, 61 mm long, with screw attached, head 10x10 mm, slot 4 mm (for the adjustment screw). The cutting edge is screwed on below with a tooth connection to the shaft. 1 1/16" measurement is embossed on the side.

2. Iron: 12.5 mm, normal grind, bevel on top. Shaft and cutting edge are one piece. Otherwise same as above.

3. Iron: 6 mm, shaft squared and taken down to 6 mm. Otherwise same as iron 2. All cutting angles 0°.