Rabbet and Bullnose plane. Left open angle piece. Sole is three-part, with the right wall piece having two cutouts and a rear handle. From the front: chip breaker 7x38 mm, molded from the right wall. Mouth 5 mm. Sole and iron stop for bullnose, 44° triangle formed from the wall with a 54 mm long sole part. Cap screw 5 mm. Bottom round stop with 6 mm thread for the side stop on the left (missing). Second mouth 5 mm. Then 44° triangle again, but with a 138 mm long sole and equipped with a fine adjustment lever. Rear cast iron handle, 5 mm step, 18x38 mm. Right wall flat finished. Depth stop 48x11 mm, 40 mm high, with slot and screw, depth adjustable from 0 to 17 mm. Below it is a cross cutter with a 6 mm thread for the right side stop. Ribbed surface with "STANLEY" cast in. Above it, a bore with a rivet for the fine adjustment lever, 75x2.5x6-17 mm, with two small 2 mm cams on top. Cap 79x39/23x7 mm, with a 24 mm long, 7 mm screw and knurled head Ø 14 mm.

Iron: 39 mm, shaft on the side 24 mm, with slot and nine setting grooves at the bottom. Cutting angle: 44°

Mark: "STANLEY" surrounded, MADE IN ENGLAND