Radius profile plane. Planes to the right on the inner radius, approximately 25 cm. Bent at the top, edges beveled, 10 cm long handle Ø 2/2.6 cm, oval, made from solid material with a wooden wedge. Right side, 2.5 cm deep with a 1 cm step, 4.1 cm high, flat. Inside: A vertical slot 1.1x0.5x5.1 cm for the depth stop. Behind it, a scoring iron with a wooden wedge. In the center, a recess for the chip hole. Left side, flat. Sole made of 3 mm iron plate, attached with seven screws, two slots for the blades, and two holes for screws Ø 6/11 mm, 35 mm long, for the side stop. Everything curved according to the radius. The depth stop is a bronze cast piece with a slider 11x5x59 mm with a slot 5x35 mm and a beautifully curved foot measuring 38x12 mm, attached with a 5 mm screw. Side stop made of wood, 12.8x4.7/3.8x1.5 cm, with two recessed 2 mm bronze plates 35x17 mm, slot 28x6 mm. The wood is straight on the outside and curved inside, attached with two screws.

Iron: 32 mm beveled Shaft: 8 mm Cutting angle: 50°

Mark: I & M. SORBY (M could be an H or K)

Scoring iron: 8 mm with point Cutting angle: 80° Shaft: 4 mm