Carved from solid wood. Oval arch approx. 7×10.7 cm (inner ⌀) with wood section (2.8×2.8 cm) running at the rear into two brackets (3.3×4.7 cm) over the shaft width. These are rounded to match the shaft profile.

The shaft is rounded at the rear top and has two grooves.

Iron holder: 9 mm square bar (9×9 mm), approx. 90 mm long, bent at right angles at 52 and 65 mm to form a hook.
The longer part has 9 mm thread (25 mm long), neither WW nor DIN standard.

A 43 mm high hand-forged wing nut sits on a washer. All iron components are very old.

Iron: 17 mm     Length: 93 mm
Angled 20 mm at bottom, beveled edge
Shaft: 12 mm square

Marking: I B N – S (uncertain)

Condition: Conserved.
Old. Good condition.