A cornice and fine rabbet plane. The upper section can be removed to convert the plane into a bullnose.

Made of curved steel, about 64 mm sole length and 35 mm total height. Two 24 and 11 mm wide openings with a 3.5 mm wide side wall, used for chip ejection. A 29 mm long threaded rod in the back. Behind, a turned knob (⌀ 14 mm) in steel, 20 mm high, with a 5 mm Whitworth 55° 20G screw. The plane body is 125 mm long, with a 6 mm Whitworth 55° 28G thread and a ridged nut (⌀ 15 mm) in front.

At the back: the plane body is 122 mm long, 28 mm wide, and 8 mm thick, with a 7 mm slot near the sole. The cast body is 2.4 mm thick on the sides, with a small 6×14 mm wooden infill on top. Two 4 mm screws hold the side fence. The lever cap is 29 mm wide and 62 mm long, with a 4 mm pivot rivet. The thumb screw has a 5 mm Whitworth 55° 24G thread and a 10 mm cylindrical head. The mouth is 4×22 mm. The cap iron is 45×26 mm, 2 mm thick. The wedge is 1.2 mm thick, with a 6 mm pivot. The rear extension is 6 mm thick, 28 mm wide, 29 mm long. The handle is 25 mm tall, with a 10 mm slot, riveted at the back. A 35 mm bronze screw with a 5 mm Whitworth 55° 28G thread and 9 ridges locks the assembly.

Iron: 32 mm (1¼″) wide, bevel on top. Shaft: 19 mm
Bevel angle ~15°