Rabbet Plane

Blade holder wooden, 6 mm hole. Iron insert 130 × 18 mm with two screws. Iron holding block 72 × 37/22/4 × 23/36 with 39 mm long 7 mm screw with 12 mm square head screwed onto the holder.

Front 14 mm beveled clamp shaft for two forecutters. On the right, a 3 mm wide nut, forecutter in front of the tapered housing ridge. Left of that is the left forecutter, five 1 mm shims and a 6 mm washer.

Whole secured by a 12 mm hole in the screwed 4 mm thick cover plate 29 × 25/16 mm with a 47 mm long bolt with 6 mm thread and 8 mm square head, clamping the 5 mm tongue. This allows replacing the 8 mm iron with a wider one up to 12 mm.

Right in the block center runs the depth adjuster in a 17 mm slot. Depth adjustment 4 to 12 mm. Rear iron held in a 4 mm slot with a slotted 12 mm bolt with 6 mm thread and 13 mm square nut.

Fence 14.8 × 15 × 2.8 cm, strongly rounded inside front and rear to 9 cm. Iron 90 × 26 × 4 mm with 40/70 mm long 7 mm clamping screw with disc head 34 × 31 × 2 mm. Hole 2.9 × 2.6 mm.

Handle wood 14.5 × 3.7 × 3 cm rounded and glued. Handle hole 9 × 2 cm, 1.6 cm deep. Underside reinforced with two inset 98 × 30 × 2 mm irons.

Iron: 8 mm, shaft 12 × 4 mm, approx. 47°. Two forecutters: 14 mm with approx. 30 mm long 6 mm slot, approx. -10°.