VICTOR CIRCULAR PLANE
Two movable cast parts connected with a 115 mm long, 13 mm iron screw, and one part equipped with a guide groove below.

Nut: Ø 45 mm, height: 9/20 mm, connected.

Plane Section: Cast iron: 40 to 65 mm long, 26 to 60 mm high, and 64 mm wide, hollow inside with a screwed-on iron stop plate, 3 to 10 mm thick, 45 mm wide and 110 mm high. It carries the lateral adjustment lever (STANLEY) with an 11 mm roller and, at the back, the fine adjustment screw made of bronze: 26 mm Ø, 20 mm high, with an 8 mm guide groove for the joint lever, which engages into the plane iron cap. In front, there is the iron cap screw. Iron cap: 0-9x4.4/20x10.5 mm with spring and eccentric lever. The 1 mm steel sole has an iron wedge thickness of 19/17x57x7 mm, with the 4x46 mm mouth set with 18 rivets. In front of the plane casting is a vertical 13 mm flat thread screw for the bending adjustment screw.

Adjustment Part: 255x64x21/45 mm, rounded at the front and back as a handle, wall thickness approx. 4 mm. Below these handles are cast slotted cams. These hold the movable 7x3x30 mm lugs. These are bolted to the sole using hinge pins. Slightly above the middle of the adjustment cast frame is a rib 30x56x32 mm with a vertical 13 mm borehole (no thread). It has an open 5 mm high and 20 mm long slot as a nut return, missing a 5 mm clamping screw.

Double iron: 44 mm

Cutting angle: 50°

Mark: STANLEY PAT APL 19.92