Steel sidewalls 2 mm thick, each with two sets of three diagonal slots and multiple perforations. Lower 15 mm formed edge inset 3 mm. On both sides above this are 3×14 mm flat steel strips, rear with four and front with two cross-head screws, divided at the iron. Between them are 15 sheet-metal lamellae, also divided, worked together with the sidewalls and steel strips into a flat 30 mm-wide sole.

The blade holder and cap are mounted on an eccentric shaft, rotatable, and guided by a 12 mm roller running in curved slots in the sidewalls. It acts as a thumb-operated hold-down lever. A lever on the eccentric shaft provides fine adjustment. Front and rear are fitted with two round Ø 40 mm plastic inserts in wall holes, serving as hand guards.

Beneath the rear insert a (red) plastic box 59×26×23 mm is inserted; it contains a screwdriver for the cross-head screws and spare blades. Mouth 6 mm.

The side fence, attachable left or right, consists of two black anodised 3 mm-thick pressed-steel L-pieces. One is tilted into the plane body and fixed from outside with a 26 mm screw threading inward. The T-shaped sliding piece with 3 cm millimetre scale reduces the planing width from 30 mm to 0 mm and is secured with the same type of screw. Supplied with box and instructions.

Iron: 30.7 mm special blades
Cutting angle: ∠ 45°
Mark: RALI SWISS MADE