FREIBURG BADEN 52

Handle made of beech.
Handle dimensions: Length = 35 cm, Diameter = 2 cm

The plane has a pre-drilled center hole of 4.8 cm diameter for the first cut. It has a total depth of cut adjustment of 80 mm, including the taper and cone with a diameter of 57-48 mm, and is approximately 50 mm long. The slot for the iron blade is through the entire 14 mm width. This iron is set with two 6 mm deep countersunk screws, secured with square nuts, 11 mm in height. The iron has a semi-circular notch above and a 51 mm long pipe with an inside diameter of 25 mm and an outside diameter of 38 mm across the entire piece. Before the cut, the cutter is adjusted between the cheek iron on the opposite side using a slanted stop. It has two slots.

Iron: Length 59, Width 22 & 27 mm
Blade: 51 mm from outside with a 5 mm set-back. It has two slots.
Groove iron: 6 mm shaft, 12 mm with slot and screw at a 90° angle.
Tenon cutter: 10 mm shaft, 17 mm with slot and screw at a 60° angle.