Body's second part is adjustable on rail fitting, lockable with a 22 mm long 6 mm knurled head screw Ø 11 mm. Upper part: front sole section with grip horn on top. Rear rounded as a grip; underneath is a small 4 mm screw on the sliding part at the front, acting as a stop to regulate the mouth width. Lower part: sliding rail piece with 6 mm thread for screw in the wedge support. Wedge iron 64x10x5/16 mm with 15 mm long 6 mm knurled head screw. Iron stop tapering to a point, in the middle 5 mm thread matching the 18 mm long preliminary thread of the 55 mm long iron adjustment screw, knurled head Ø 16 mm. On this runs the 16 mm long 6 mm threaded rear part with a small 18/11x12/8x16 mm sliding block with a 2 mm transverse groove fitting into one of the eight transverse grooves in the iron shaft. By turning this adjustment screw clockwise, the iron is pushed forward. The lower part of the plane can be used as a bullnose plane.

Iron: 20 mm, shaft 10 mm with 2 mm adjustment grooves below.

Bevel on top: 20° ⟶ 16° = approx. 36°

Mark: STANLEY MADE IN ENGLAND