Bullnose Plane – Cornice Plane

Two-part body made from cast bronze. The upper section includes a 7 mm chipbreaker and a mouth that is adjustable from 0 to 5 mm. It has a rounded step over the chip ejection slot, 4 mm thick wall, and 5 mm lower flat area with a 6 × 11 mm slot.

The lower part is a cast U-shaped rail with 15 mm high walls and four small stops. It’s beveled at 35° in the front and rear. Located 55 mm from the front and in the center is a 9 mm lug with 4.5 mm thread and a 20 mm screw to secure the upper part.

The cap iron (56 × 13 × 0–5 mm) has 4 mm threading and is held in place with a 17 mm long knurled screw (Ø 11 mm).

Iron: 26 mm wide (1"), with a 14 mm shaft. Bevel is approx. 30° on top. Cutting angle: approx. 70° (40° bed + 30° bevel).

Condition: Good, with traces of red paint.