Cornice & fine plane. The plane becomes a bullnose by removing the upper part.

Upper Part: Curved steel part, with a 6 mm long chip breaker at the front. In the middle, a 41 mm long, 7 and 16 mm wide opening with 5 mm sidewalls and longitudinal guide rails, 22.5 mm wide, 1.5 mm high. Curved at the rear as a handle. Inside and front, there is a 4 mm thread in the steel with a small threaded bolt for adjusting the plane's size. The upper part is held with a 22 mm long 6.5 mm screw, thread WW 55° 28 G, with a knurled head Ø 13 mm.

Lower Part: 95 mm long with an iron stop at the sole. The back is 56 mm and the bottom is 67 mm long box-shaped. Sole: 4 mm and 26 mm high, with 14 mm long, 7 mm thick sidewalls with guide rails and a 6.5 mm thread. At the back, the sole is inclined at 15° with the support block of the iron adjuster, 9x11 mm and 7.5 mm thread with a block of 16 mm height in front of it. Iron adjuster: 16 mm high block, underneath 17.5x14 mm, above 10x11.5 mm with 7.5 mm thread and a ½ mm adapter that fits into the grooves of the plane iron. One 55 mm long double screw with a ribbed head Ø 16 mm, with a front part 19 mm long, 5.4 mm WW 55° 28 G thread, and a 6.5 mm long screw behind it with the same thread.

Flap: 67 mm long, 18 mm wide, 6 mm thick, with an 18 mm high support in the front. At the rear, a 5 mm thread with an 18 mm long screw, WW 55° 28 G thread.

Iron: 25.5 mm (1 inch), bevel on top, shaft 16.5 mm with 9 grooves on the underside.

Cutting angle: 15°

Mark: STANLEY MADE IN U.S.A.