Base plane. Wooden base with an upper rounding in two 2 mm steps, rounded corners. On top, a bronze casting 61/31x140x6-18 mm. At the front, approximately a Ø 42 mm vertical hole. Side runners for the two turned wooden handles are screwed on, with wooden handles Ø 2.9/1.7/4.5 cm and 4.5 cm in height. Between them, the bronze piece is fastened with two screws onto the wooden base. The bronze casting is shaped at the back as a square, 17x16x18 mm. It has a 6.5 mm vertical slot for the iron, with a horizontal 10 mm hole. A 120 mm bolt, 33 mm long, with a 15 mm thread and at the front a 6x6 mm square hole for the iron shaft. A wing nut Ø 16 mm, 3x40 mm, clamps the iron. The bolt and screw are made of bronze.

Iron: 6 mm, 25 mm angled shaft, 6x6 mm. Cutting angle: almost 0°