Round rod plane for axle hubs up to 8.5 cm Ø. Axle hub or spoke nipple plane. Planes internally. Two wooden plates 8.6x19x4 cm. Both plates reinforced with a 1.5 mm iron plate 86x190 mm and 8 or 9 screws.

The adjusting piece. In the middle, semicircular cutout Ø about 8 cm and 0.8 cm deep. An 80 mm long set screw, thread neither WW nor DIN, with a cylinder head. Nut screw in the wood slightly inside the wood screw thread Ø 1.9 cm, next to it two 1.2 cm holes for the guide bolts into the wood. At the other end of the adjusting piece are ten 10 cm long, 1.2 cm bolts with 4.5 cm side spacing. In the short outside are two screw grips, each 3x0.3 cm slot for the 3x3x3.0 cm wood from the holding wood and 10 cm thread Ø outside 1.9 inside 1.3 cm thread pitch 4.6 mm.

The plane part is the same but mirrored. Both parts have 140° mutually standing plates with 4 screws each as guides. In the adjusting piece 79x25 mm, in the plane part 79x30 mm with a side open slot from 70x4 mm as a mouth. Above is the chip breaker 73x5 cm with a 40° slanted back wall with a recessed screw for the plane iron, with a 16 mm square nut on the lower plate.

Iron 72 mm with slot < 40°. Side cutter 5x15 mm wide 60x36 mm with 2 slots and screws screwed onto the plane iron.
Joh Bandli Maienfeld 19
Conserved