Cast iron 5 mm with edge reinforcement. Front: round knob Ø 1.8x3.2 cm, 6.8 cm high. Rear: open handle 7x2.4x10.4 cm, both made of wood. Middle: iron, cutout 90x8/16 mm, left of it a console 63x20/23x20 mm, outer front angled 3° down and 40° up. On it: flap 62x19x3 mm, bent downwards, with two screws as a blade holder. Sole: partially ground with five longitudinal grooves. Two screws with threads on the left 110 mm apart for a side stop 21.9x13/32x23/40 mm, adjustable in an angle position. Two wedge plates, spaced apart downwards. Adjustable between 0 and 15 mm with two flat-head screws.

Accessory part: Cast piece with a side angle piece, two slots, and two depth adjustment screws. Two opposite inclined iron stops angled at 40°, with a flap like the one on the plane, held together by a round frame. They diverge by 4° towards the front. This accessory is placed on the plane over the console under the two screws, set at the top with two screws, and clamped sideways. The flap and iron must be disassembled before inserting.

Blade: None available.

Condition: Good (without blade).