Carved from solid wood. Cuts on the underside.

Rounded arch tapering into the shaft (5.2×10.5 cm). Rear part rounded on the sides.
Top rim of the arch recessed 1 cm with grooves top and bottom.
Additional 2–3 cm long notches on the rear edges.

Top of the arch richly carved with a four-petal flower and ferns.
Hole edge carved as a round garland.

Iron holder: 10 mm screw, thread neither WW nor DIN standard, angled bar to the left.
33 mm high wing nut, with 44×31 mm plate embedded in the wood.

Protective cover for the iron hole on top: House-shaped plate (30×40 mm) nailed on.
Bottom slightly recessed over the iron.

Iron: 12 mm wide
Bent 27 mm at bottom
Total height: 147 mm
Assembled with two rivets

Condition: Conserved.
Good condition. Slight crack at bottom.