Marking: Large bell on the lever

Iron frame in beech

Iron frame with 3 screws in and on the wood. Round grip at the front 2 7/4.7 cm high, 4.5 cm screwed on, just behind the iron hand grip 8.5x2.3x9 cm with two screws, both made of wood. The wood is an ordinary beam 66x4.8x4.1 cm. The iron frame (with 'S' in cast) has two 38 mm high backsides, the front with a 44° inclined edge. In it, there is a 23 mm wide wave with 10 mm diameter, on a 4 mm bolt turnable, with nut lugs next to a 37 mm long crank. The handle of this crank is 22 mm long, turnable in a 70x5x8/12 mm bearing plate that has two finger plates. In the nut slot, the iron can be moved a few millimeters forward. The plane lever cap 110x10/10/146x6/28 mm has a 26 mm long 6 mm screw with a round head of 21 mm diameter. It is held by a lateral 5 mm bolt that goes through.

Iron: 66 mm (2 9/16 inches) Cutting angle: 44°

(In THE STANLEY PLANE No.129 (There only 20 inches long iron 2 3/8 inches wide) as FORE PLANE)