Molding Plane – Hollow Profile with Fence

This right-handed plane features rounded top edges and decorative line carvings. It uses a wooden wedge. On the upper right side, there is a piece of boxwood (approx. 19.5 × 0.7 × 3.2 cm) with a groove and hollow profile at the bottom. Below that, the wedge and iron are exposed, with the chip ejection opening on the underside.

The depth stop is adjustable using small screws and consists of a two-piece wooden block (about 19.5 × 0.4 × 1.2 cm). On the lower left side, there is a side fence made of walnut, flat against the side and measuring 0.6 cm wide and 0.3 cm high.

The blade is 5 mm wide, with a cutting angle of about 50°.