Formed from 1.25 mm sheet steel. Front with lateral bends forming finger grips. Top open, rear rising to a point. Sole approx. 30 × 24 mm. Mouth 24 × 4 mm. Pivoting lever cap 13 × 25 mm, 3 mm thick, bent upward; lower sides fitted with lugs engaging the body. Centre with 4 mm thread for the 13 mm domed screw. Assembly from above: screw, washer, lever cap, two additional washers, and an adjusting lever 29 × 8/16 × 3 mm, slightly upward bent.

Iron: 21 mm, 7 mm slot
Cutting angle: approx. 40–45°

Condition: Good.