Groove plane with wooden screws & wooden gears. Ornamental band on the upper sides. Chip hole on the right. Wooden wedge. The blade is two-part iron, 272x40x6/3 mm (wedge-shaped). The thicker part is embedded 2:4 cm into the wood. Fixed depth stop on the right, 15 mm wide and high. The adjustable depth stop to the left of the tongue, iron 272x17/10x4 mm, with two 51 mm high, 16x11 mm squares welded on top, with a 48 mm long, 6 mm internal thread. Attached small plates, 50x20 mm, hold at the top, front, and back, each a 85 mm long, 6 mm screw with a handmade oval plate head and retainer. Thread not measurable. Depth stop from 0 to 1.5 cm. Side stop 27x2.5x9.5 cm with nailed-on support woods 16x1.1x1.2 cm. In the stop wood, three gears made of boxwood are installed, 7.5 cm in diameter and 1.4 cm thick. Each has 24 teeth about 1 cm high. The outer two have internal threads and run on the wooden screws. The middle one runs in the wooden wall and has an external pivot pin. The whole thing is covered inside with a wooden board 27x8x0.6 cm, lightly nailed. Turning clockwise opens the stop. Two wooden screws, 17 & 13 cm long, diameter outside 2.1 cm, inside 1.5 cm, with a thread pitch of 6.3 mm, are embedded in the plane and covered outside with squared wood. Two turned nuts, diameter 3.5/5.2 cm, 5.2 cm long, lock the stop onto the gears. All screws have a normal right-hand thread. Side stop from 1.2 to 6 cm.