In the middle of the plane is a block of 5.9/7 cm with a 23 mm hole. The pipe is open at the top and inserted into the hole at the front 3 mm wall thickness. The entire length of the top has a milled 21 mm wide straight surface. Below, it is fixed with two screws to a 3 mm steel plate, which has a 25 mm hole inside and 58 mm outside, fixed to the wood with four screws as a stop. The milled straight surface on top carries two angled 12x10 mm lugs with a threaded hole on the left and right for the blade, which is held with two screws and can be adjusted further out. The lugs can be set deeper. A curved 9x3 mm flat iron bar 100 mm long is welded outside as reinforcement (repair). The wooden handle is 5.7 cm long, 5.9-7 cm at the top and has 10 cm long handles on the left and right with a diameter of 2.9/3.2 cm, all wood from one piece.

Iron 63 mm with two slots. Approximately 75°. The tenon cutter 23 mm is welded at a right angle to the iron.

Condition: Okay, small crack in the wood (previously repaired).

For 7 cm wood lengths.